Material Safety Data Sheet Product Name: SilEnergy Page 1 Section I – Manufacturer Identification Manufacturer’s Name: Brewer International Address: PO Box 690037
Vero Beach, Fl 32969 Emergency Phone: Chem Tel (800) 255-3924 Information Phone:
(800) 228-1833 Section II – Composition/Information on Ingredients Silicone Copolymer, Nonionic Surfactant, and Propylene glycol blend. Nonpylphenol Ethoxylate CAS#127087-87-0 Section III – Health Hazard Data Eye: Causes severe irritation, experienced as discomfort or pain, excess
blinking and tear production, redness, swelling, and chemical burn of the eye. Skin: Brief contact is not irritating. Prolonged contact may cause
redness. Ingestion: May cause abdominal discomfort, nausea, vomiting and diarrhea. Inhalation: Mist may cause irritation of the respiratory tract,
experienced as nasal discomfort and discharge, with chest pain and coughing. Other Effects: No exposure limits established by OSHA. This material can
cause injury if disposed directly into the lung. Section IV – Emergency and First Aid Procedures Eye: Immediately flush eye with water and continue washing for at least
15 minutes. Obtain medical attention. Skin: Remove contaminated clothing. Wash skin with soap and water. Obtain
medical attention if irritation persists. Wash clothing before reuse. Inhalation: Remove to fresh air. Obtain medical attention if symptoms
persist. Ingestion: Give two glasses of water. Do NOT induce vomiting. Obtain
medical attention. Toxicology: Not Known Other: Treatment of overexposure should be directed at control of
symptoms and the clinical condition of patient. Product Name: SilEnergy Page 2 Section V – Fire Fighting Measures Flash Point: 360 Deg F. Fire Extinguishing Media: Foam, Water fog, Dry chemical, ABC fire
extinguisher. Fire and Explosion Hazards: This material may produce a floating fire
hazard. Fire-Fighting Equipment: Self-contained positive breathing apparatus and
protective clothing should be worn. Section VI – Accidental Release Measures If material is released or spilled wear eye and skin protection. Floor may be
slippery; use care to avoid falling. Contain spill immediately with inert
materials (e.g. sand, earth). Avoid discharge to natural waters. Transfer
liquids and solid diking material to suitable containers for recovery or
disposal. Check local, state, and federal regulations. Section VII – Handling and Storage Use with adequate ventilation. Wash thoroughly after handling. Keep away from
heat, sparks and flames. Section VIII – Exposure Controls and Personal Protection Ventilation: Adequate ventilation. Respiratory Protection: If vapors present, use approved respirator. Skin Protection: Use of protective clothing is recommended. Eye Protection: Wear full-face shield or goggles. Exposure Guidelines: Use impervious gloves. Repeated skin contact could
cause dermatitis. Section IX – Physical and Chemical Properties Boiling Point: 150 Deg. F. Vap. Pressure: NA Vap. Density: NA Sol. in water: Yes Sp. Gravity: 1.06 @25 Deg.C. Appearance: Clear Odor: Low chemical odor. Product Name: SilEnergy Page 3 Section X – Stability and Reactivity Stability: Stable Incompatibility: Avoid high temperatures and strong acids. Hazardous Decomposition Products: Burning can produce carbon monoxide
and/or carbon dioxide. Hazardous Polymerization: Will not occur. Section XI – Toxicological Information Section XII – Ecological Information **Not Known** Section XIII – Disposal Considerations Check local, state and federal regulations. Section XIV – Transport Information NMFC number is 4610, adjuvants. NFPA rating is 1- health, 1- flammability, 0-
reactivity, and 0- specific hazard. Section XV – Regulatory Information Sara Hazard Category: This product has been reviewed according to the EPA
hazard categories under section 311 and 312 of SARA Title III, 1986, and is
considered, under applicable definitions, to meet the following categories: Hazardous Components at level which require reporting are: None OSHA Hazard Communications Standards, 29 CFR 1910.1200 This product is non-hazardous. Toxic Substances Control Act (TSCA): All components of this product are on the TSCA inventory or are exempt from
TSCA Inventory requirements. The information herein is given in good faith, but no warranty, expressed or
implied, is made. Consult Brewer International for more information. It is the
user’s obligation to determine the conditions of safe use of the product. Date Revised: August 29, 2007